Shop

CLS113RG-W7AE

Enclosed Subwoofer System with Single 13W7AE-D1.5 Subwoofer Driver, Black Carpet (1500 W, Dual 1.5 Ω) - Sealed Enclosure

For those who seek the ultimate in compact-enclosure sub-bass fidelity, we offer this sealed ProWedge™ system, in which the superb performance capabilities of the W7AE subwoofer driver are harnessed within a compact, sealed enclosure. This system has it all: extension, impact, detail and smooth response... at any listening level.

This enclosure design has been carefully engineered to the optimum sealed enclosure alignment for the 13W7AE-D1.5 and has been fine-tuned through extensive real-world listening.

This subwoofer system is shipped wired, loaded and ready to connect via a five-way binding post terminal.

The angled-back design saves precious cargo space by allowing the enclosure to fit tightly against the back of a vehicle's rear seat.

Finish: Black, high-grade automotive carpet, with gloss-black laminated decorative front baffle trim. Three solid aluminum bars provide stylish and rugged woofer protection.

Construction: CNC-Cut High-Grade MDF

Recommended amplifier power: 500 - 1500W

Nominal Impedance: Dual 1.5 Ω

JL Audio HD600/4

These Class D amplifiers use less power, take up less space, and generate less heat than traditional amp designs — you can even stack them up to create a sweet-looking installation.

HD Series amplifiers reproduce your music with exceptional accuracy, so you'll hear high-fidelity sound even under the most demanding conditions. JL Audio uses Single Cycle Control™ technology to eliminate the excessive signal distortion that's plagued Class D amplifiers in the past. Differential-balanced inputs eliminate noise before it hits the preamp stage, and allow you to connect the amp to just about any in-dash stereo. You'll hear clear, true, studio-quality audio, exactly what you expect from JL Audio.

General Features:

• 4-channel subwoofer amplifer
• 150 watts RMS x 4 (1.5 - 4 ohms per channel)
• 300 watts RMS x 2 bridged (3 - 8 ohms per channel)
• variable high- and low-pass filter (50-500 Hz 12 or 24dB/octave)
• subsonic filter and output polarity control
• removable power and speaker plugs
• optional wired remote for level control
• Class D amplifier design
• MOSFET power and output stages
• differential-balanced inputs eliminate noise from your vehicle's electrical system
• speaker- and preamp-level inputs
• preamp outputs
• 4-gauge power and ground leads and a 80-amp fuse recommended — wiring and hardware not included with amplifier
• 10-3/4"W x 2"H x 7-7/8"D
• no onboard fuses — when installing multiple amps in a system, an additional 80-amp in-line fuse between the distribution block and the amplifier is recommended